SPC PV 600, Hakel SPC PV 600, chống sét hệ thống quang điện, chống sét hệ thống điện quang, chống sét hệ thống quang năng
This product is no longer in stock
Availability date:
SPC PV 600, Hakel SPC PV 600, chống sét hệ thống quang điện, chống sét hệ thống điện quang, chống sét hệ thống quang năng
SPC PV 600, Hakel SPC PV 600, chống sét hệ thống quang điện, chống sét hệ thống điện quang, chống sét hệ thống quang năng
Recipient :
* Required fields
or Cancel
SPC PV 600, Hakel SPC PV 600, chống sét hệ thống quang điện, chống sét hệ thống điện quang, chống sét hệ thống quang năng
SPC PV is a lightning and surge arrester type 1+2 according to IEC EN 61643-11 and EN 50539-11. It is designed for protection of positive and negative busbars of photovoltaic systems against the surge effects. These arresters are recommended for use in the Lightning Protection Zones Concept at the boundaries of LPZ 0-2 (according to IEC EN 62305). Particular varistor sectors are equipped with internal disconnectors, which are activated when the varistors fail (overheat). Operational status indication of these disconnectors is partly mechanical (by exserted red signaling target in case of failure) and partly remote monitoring (by potential free change over contacts – only DS types).
Test class according to EN 61643-11 ed. 2 and IEC 61643-11 | TYP1+2, CLASS I+II | |
Maximum continuous operating voltage | UC | 650 V DC |
Open circuit voltage of PV generator | UOCSTC | U OCSTC < U cpv /1,2 = 540 V |
Short circuit withstand | ISCWPV | 25 A |
Impulse discharge current for class I test (10/350) | Iimp | 12,5 kA |
Charge L/N | Q | 6 As |
Specific energy for class I test L/N | W/R | 36 kJ/Ω |
Application | L+/L-, L+/PE, L-/PE | |
Nominal discharge current for class II test (8/20) | In | 25 kA |
Voltage protection level at In | Up | < 2,4 kV |
Response time | tA | < 25 ns |
LPZ | 0-1 | |
Housing material | Polyamid PA6, UL94 V-0 | |
Degree of protection of enclosure | IP20 | |
Operating temperature | ϑ | -40°C ... +70 °C |
Cross-section of the connected conductors (at tightening moment of clamps 3 Nm) | 35 mm2 (solid) 25 mm2 (wire) |
|
Method of assembly | DIN rail 35 mm | |
Failure signalisation (S) | pushed in - ok / pushed out - failure | |
Weight | m | 900 g |
Lifetime | min.100 000 h | |
Article number | 10 168 |
Catalogue |