search

SPC12,5 DS, Hakel SPC12,5 DS, chống sét lan truyền, thiết bị chống sét lan truyền nguồn điện 1 pha Hakel, chống sét, Hakel

0 ₫
Thuế

SPC12,5 DS, Hakel SPC12,5 DS, chống sét lan truyền, thiết bị chống sét lan truyền nguồn điện 1 pha Hakel, chống sét, Hakel

Số lượng

SPC12,5 DS, Hakel SPC12,5 DS, chống sét lan truyền, thiết bị chống sét lan truyền nguồn điện 1 pha Hakel, chống sét, Hakel

 

SPC12,5 DS

SPC12,5 DS

SPC12,5 DS is a metal oxid varistor lightning and surge arrester type 1+2 according to EN 61643-11 and IEC 61643-11. These are recommended for use in the Lightning Protection Zones Concept at the boundaries of LPZ 0–1 (according to IEC 1312-1 and EN 62305), where they provide the equipotential bonding and discharge of both, the lightning current and the switching surge, which are generated in power supply systems entering the building. The use of the lightning current arresters SPC12,5 is mainly in the power supply lines. The main use of SPC12,5 arrester is in structures of LPL III – IV according to EN 62305 ed.2.

Double terminals of the device allow the “V” connection at the maximum current-carrying capacity of 125A.

Internal wiring diagram
Internal wiring diagram
Dimension drawing
Dimension drawing
Installation diagram
Installation diagram
PARAMETERS
Test class according to EN 61643-11 ed. 2 and IEC 61643-11   TYP1+2, CLASS I+II
Maximum continuous operating voltage UC 275 V AC / 350 V DC
Impulse discharge current for class I test (10/350) Iimp 12,5 kA
Charge L/N Q 6 As
Specific energy for class I test L/N W/R 36 kJ/Ω
Nominal discharge current for class II test (8/20) In 25 kA
Maximum discharge current Imax 50 kA
Voltage protection level Up < 1,2 kV
Temporary overvoltage (TOV) UT 335 V/5 s
Response time tA < 25 ns
Max. back-up fuse   160 A gL/gG
Max. back-up fuse („V“ connection)   125 A gL/gG
Short-circuit withstand capability 160 A gL/gG ISCCR 80 kArms
LPZ   0-1
Housing material   Polyamid PA6, UL94 V-0
Degree of protection of enclosure   IP20
Operating temperature   -40°C ... +80 °C
Cross-section of the connected conductors (at tightening moment of clamps 3 Nm)   35 mm2 (solid)
25 mm2 (wire)
Method of assembly   DIN rail 35 mm
Failure signalisation (S)   pushed in - ok / pushed out - failure
Potential free signal contact (DS) (recommended cross-section of remote monitoring max.1 mm2)   AC: 250 V / 0,5 A, DC: 250 V / 0,1 A
Lifetime   min. 100 000 h
Weight m 240 g
Article number   10 644
 
CERTIFICATIONS
DOWNLOADS
Catalogue

Tham Chiếu Cụ Thể